Water Heater Installation
New installation for a home, remodel or replacement, sized to the household.
The dip tube carries cold water to the bottom of the tank. A water heater dip tube replacement fixes the common problem of hot water that runs out far too fast.
Cold water enters at the top of the tank. The dip tube carries it down to the bottom, so the hot water at the top is pushed out to the taps first.
Without a working dip tube, cold water mixes with the hot water at the top, and the shower goes cold after a few minutes.
Hot water that runs out much faster than it used to, lukewarm water even with a full tank, or small white plastic pieces in tap aerators are the classic signs.
The problem is most common on heaters from the 1990s, when a batch of dip tubes was made from plastic that broke down in hot water.
The provider drains the tank, removes the cold-water inlet fitting, pulls the old tube and fits a new one, then refills and tests the heater.
It is a small part and a straightforward job on a tank that is otherwise in good shape.

New installation for a home, remodel or replacement, sized to the household.
Flushing, anode checks and routine care that help a heater last longer.
Diagnosis and repair of tank, tankless, gas and electric units.
A good dip tube lasts the life of the heater, but some 1990s tubes failed early. If yours has broken, a new one should last for years.
No — it is replaced. The part is inexpensive, and the job is usually done in the same visit as a flush or an anode check.
The usual causes are a broken dip tube, a failed lower element, a failed thermostat, or a heater that is too small for the household. A provider can test each one.
Call (480) 919-8156 and describe what your water heater is doing. Elite will connect your request with an available independent local provider — the provider handles diagnosis, pricing, scheduling and the work directly with you.